The Afterneath sounds a lot like it looks – a wizard in a cave in a box. You are the wizard – or sorceress, if you prefer – and the cave is your instrument’s signal, vast, expansive, and magical. Do you go inside? Roll a d20 to proceed!
Once inside, a reflection of light from an unknown source catches your eye, and you notice the walls of the cave have a bizarre sheen. You timidly inch closer to the walls of the cave. Placing your hand gently on the cavern wall, you feel the rock move. The cave is alive! Alarmed, you emit a loud gasp, which reverberates throughout the subterranean landscape. Upon further listening, it appears as though the reverberations of your voice are in fact a swarm of short digital delays which may be used to create wild and cavernous reverbs, or scattered, short, rhythmic delays with bizarre characteristics.
Length: Controls the decay length of the reverb.
Diffuse: Adjusts the spread of the reverb. Sharper with more attack counter clockwise, more
ambient and washy as you turn it clockwise.
Dampen: Clockwise for brighter tones, counter clockwise for darker tones.
Drag: This digital reverb is made up of a bunch of short delays, this separates the delay lines
creating a stuttering, pingy effect. This is the coolest control on the Afterneath; we highly advise
slowly turning this while you let notes ring out for a cool warped speed effect. More delay as you
turn it counter clockwise, more reverb as you turn it clockwise.
Controls the regeneration of the reverb, turn clockwise for more wash and echos,
counterclockwise for less. This will self oscillate if turned up high.
Mix: Blends the wet signal into the dry. Though it does not actually go full wet, it will gradually
lower the clean level as you turn it clockwise and give the appearance of full wet.
Any regulated 9 volt DC power supply with a negative 2.1mm center barrel intended for musical
instruments. Daisy chaining is not recommended but will not hurt the device. Current draw is
around 65ma }