“Nightlight” is an asymmetrical, full-bodied overdrive/distortion. The structure of the gain is detailed and complex. The gain will not collapse on itself/compress at high gain settings. This pedal is very dynamic and touch sensitive.

We designed this pedal to work well with various guitar and amp combinations, using every combination we could think of... vintage, boutique, budget, etc. Then, we spent a year sharing the pedals with session players in Nashville. This is the final product, and we like it a lot!

The controls are simple, just three knobs. Start with each control at 12:00 (midnight), and then experiment. We worked hard to make sure the 12:00 setting was a good starting place out of the box.

- Level: Level controls the volume of the output.
- Tone: Tone controls the darkness/brightness of the tone.
- Drive: Drive controls the amount of overdrive/distortion.

Notice the tone knob sweep is musical and usable through the entire range. As you back off the guitar’s volume pot, the pedal cleans up. At higher gain settings the sound does not collapse on itself.

Specifications:

- Made in the USA.
- Designed, built and tested in Nashville, Tennessee.
- True Bypass Switching. The devices use standard mechanical true-bypass switching. Audio will pass through if the switch is turned off, and/or if there is no power to the pedal.
- Switchcraft jacks
- 9V only. External power supply required. Power supply not included. There is no battery clip inside.
- 9-Volt DC power supply with a 2.1mm center-negative barrel connector.
- Current Draw: Less than 10 mA
- (9v) DC power only. Do not run at higher voltages.
- Length x Width x Height (incl. sockets, knobs, etc.): 4.92” x 2.62” x 2.23” (125 mm x 66.5 mm x 56.6 mm)