Zvex - TB-1 Teaball

$329.00
Steve's Code: 76669
By ZVex

Description

Introducing the model TB-1 Tea Ball Microphone by ZVEX Effects, designed for specialty use

on stage and in the studio. The special circuitry of the TB-1 causes it to reject sound from

sources that are further than an inch or so away from the grille. This allows the mic to be placed

on stage in a loud environment and plugged directly into a guitar amp that’s turned up to a level

that would cause any normal microphone to squeal furiously. In the studio when recording a

guide vocal track in a live recording room, the TB-1 will reject the amplifiers and drums. This

way the guide vocal can be used for rough mixes without fear of hearing other instruments or

room ambience loudly in the background.



Why is it called the Tea Ball Microphone? It’s actually built inside a stainless steel tea ball, the

kind of device used to make a hot mug of goodness from a tin of loose tea. The clip that holds

the tea ball shut is used to open it up to change two CR2032 batteries. These have a life of

about 100 hours and presently cost less than $10 for 20 units on Amazon (Sony CR2032). The

mesh on the tea ball will never chip your teeth like an SM58 because it’s quite springy. That’s

important because the best sound from this mic comes from putting your mouth right up against

it. The entire mic disassembles easily by unplugging the electronics and lifting out the internal

foam windscreen which can be washed in soapy water. Be sure to dry it before reassembling.

The mesh ball is suspended inside a thick copper hoop using three springs for a look like

something from the early part of last century.



The TB-1’s output level is similar to that of a guitar. It has a 1/4” female jack that runs smoothly

parallel to the microphone stand. The mic is powered up by being plugged in and turned on with

a switch on the back. When the mic is unplugged, the battery will not drain no matter which

position the power switch is in. When the mic is live, an LED gently glows near the switch,

visible from FOH so that the sound engineer can be sure it’s working. Enjoy!